This one is for my wife:
If you look closely, you can see there was a ton of stringing. Stringing is usually caused by a nozzle that's too hot, retraction settings that are too low, or a combination of the two. I'll have to adjust those on the next print, because it was a pain in the butt to clean up all those protrusions:
Original file here.
Nozzle: 230C
Bed: 100C
Chamber: 50C
Layer height: 0.2mm
Speed: 40mm/s
Time: 15 hours
Material: Hatchbox ABS
Edit: For comparison:
If you look closely, you can see there was a ton of stringing. Stringing is usually caused by a nozzle that's too hot, retraction settings that are too low, or a combination of the two. I'll have to adjust those on the next print, because it was a pain in the butt to clean up all those protrusions:
Original file here.
Nozzle: 230C
Bed: 100C
Chamber: 50C
Layer height: 0.2mm
Speed: 40mm/s
Time: 15 hours
Material: Hatchbox ABS
Edit: For comparison:
No comments:
Post a Comment