Bed is apparently out of level, and a second belt (for the Y tower) is showing wear. I checked the pulley on the stepper motor (the source of the problem last time) and it is out of alignment, despite being optimal a few weeks ago.
I have a few other upgrades I was planning to tackle after my current roll of filament, but I think I'll just take care of them now.
So...probably won't be printing for a week or two.
EDIT: ok, the bed probably didn't change at all. It looks like the worn belt slipped one or two spots, which puts the hot end on a plane slightly askew of the bed.
I have a few other upgrades I was planning to tackle after my current roll of filament, but I think I'll just take care of them now.
So...probably won't be printing for a week or two.
EDIT: ok, the bed probably didn't change at all. It looks like the worn belt slipped one or two spots, which puts the hot end on a plane slightly askew of the bed.
No comments:
Post a Comment