Homing the axes:
Printing a calibration cube:
Turns out it was only half a cube:
Progression of my first three attempts at the calibration cube:
Printing the PEEK heat break duct:
Intermediate shot of my first non-functional print. You can see the tiangular infill pattern (30% infill in this case):
Final result - a black, plastic-y diamond
A coworker stomped on it (after asking) and there was no visible damage. Original file here.
Printing a calibration cube:
Turns out it was only half a cube:
Progression of my first three attempts at the calibration cube:
Printing the PEEK heat break duct:
Intermediate shot of my first non-functional print. You can see the tiangular infill pattern (30% infill in this case):
Final result - a black, plastic-y diamond
A coworker stomped on it (after asking) and there was no visible damage. Original file here.
No comments:
Post a Comment