I picked up this model for belt tensioners specifically designed for the Rostock.
The first print failed because I was lazy and didn't do proper bed prep:
The second print succeeded.
I set up the print file with two cams in the center, and the tightening tool on the outside. Later, I printed four more cams (two for each tower).
Here's the tower without the cams:
And here's the tower with the cams.
I had to buy 3" #6 bolts to make this work. They're relatively hard to find. Fortunately, Lowes had them in stock (after checking Amazon and Home Depot).
The first print failed because I was lazy and didn't do proper bed prep:
The second print succeeded.
I set up the print file with two cams in the center, and the tightening tool on the outside. Later, I printed four more cams (two for each tower).
Here's the tower without the cams:
And here's the tower with the cams.
I had to buy 3" #6 bolts to make this work. They're relatively hard to find. Fortunately, Lowes had them in stock (after checking Amazon and Home Depot).
No comments:
Post a Comment